Take the fixed panel support bracket apart and double check that reassembly is being done per the installation guide. There are 2 sizes of set screws. Be sure to check you have the correct size in the right location. Please refer to page 7 and page 25, step 34 for visuals of the screw sizes and proper locations of their installation.
Related FAQs
-
Contemporary Pivot: Where can I find the hardware to install my Semi-Frameless Contemporary Pivot Door?
-
Classic500/EverEdge Shower Door: What do I do if the inside rollers are loose and easily pop out of the top track?
-
Classic500/EverEdge Shower Door: What height does the top track install at for my Classic500/EverEdge shower system?
-
Ashmore Shower Door: Are the side seals supposed to stay on my Ashmore Shower Door?
-
Traditional Sliding Shower: Why are the back of the handles and/or rollers hitting when the doors try to bypass?
-
Traditional Sliding Shower: Why is the outer door on my Traditional Shower Door hard to open?
-
Mod Sliding Shower: Where do I place the template for the Mod shower door?
-
Mod Sliding Shower: What do I do if the template for the Mod door goes up above my enclosure?
-
Contemporary Sliding Shower: Where do I install the bottom track for my Contemporary Sliding Shower or Tub Door?
-
Contemporary Pivot: I can’t get the clamps on my Contemporary Pivot Door. What do I do?
-
Contemporary Pivot: Why will my door not close on my Contemporary Pivot Door?
-
Contemporary Pivot: Why is water leaking under the glass door panel for my Contemporary Pivot Door?
-
Contemporary Pivot: Why is there water leaking under the bottom track or bottom pivot bracket for my Contemporary Pivot Door?
NEED MORE HELP?
CONTACT SUPPORT.